Search the documentation
Enter at least 2 characters
 |
CAE Fidesys 9.0 Documentation |
Enter at least 2 characters
|
CAE Fidesys 9.0 Documentation |
Restrictions in the form of temperature values can be imposed for most types of geometric and grid entity. Such restrictions also apply to thin-walled elements.
To create or change temperature boundary conditions , you should:
Select on the Command Bar Mode - Boundary Conditions, Entity - Temperature.
Depending on the situation, choose Action - Create or Action - Modify.
Using graphical user interface elements set the identifier (ID) or name of a set of boundary conditions, specify entity that are subject to restrictions, and enter the temperature value.
Click Apply.
These interactive operations correspond to the commands:
create temperature [ID] [name <'name'>] [{add | on} {nodeset | volume | surface | curve | vertex | hex | tet | face | tri | edge | node} <entity_list>] [value <val>]
create temperature [ID] [name <'name'>] [{add | on} {nodeset | volume | surface | curve | vertex | hex | tet | face | tri | edge | node} <entity_list>] [{top <val> bottom <val> | [middle <val>] [gradient <val>]}]
modify temperature {ID_list|'name'|all} [name <'name'>] [{add | remove} {nodeset | volume | surface | curve | vertex | hex | tet | face | tri | edge | node} <entity_list>] [value <val>]
modify temperature {ID_list|'name'|all} [name <'name'>] [{add | remove} {nodeset | volume | surface | curve | vertex | hex | tet | face | tri | edge | node} <entity_list>] [{top <val> bottom <val> | [middle <val>] [gradient <val>]}]
The value parameter defines the value to be entered temperatures.
To set temperature boundary conditions on thin-walled elements, the parameters top, bottom, middle and gradient are used. These parameters are valid in the following combinations: top and bottom, middle and gradient, only gradient or only middle.